1. The angle steel and channel steel should be stacked in the open air, that is, the mouth should face down, and the I-beam should be placed vertically. The I-channel surface of the steel should not face upward to avoid water accumulation and rust.
2. There should be a corresponding channel between the stacks. The inspection channel is generally 0.5m, and the access channel depends on the size of the material and the transport machinery, generally 1.5~2.Om.
3. The stacking height of
thick-walled steel pipes shall not exceed 1.2m for manual work, and 1.5m for mechanical work and the stack width shall not exceed 2.5m.
4. It is forbidden to store items that corrode steel around the stack of thick-walled steel pipes.
5. The bottom of the stack is raised. If the warehouse is on a sunny concrete floor, it can be raised by O.1m; if it is a mud floor, it must be raised by O.2~0.5m. ~O.5m, the height of the sand and mud surface is 0.5~O.7m.
6. For the thick-walled steel pipes stacked in the open air, there must be wooden pads or stone strips underneath, and the stacking surface is slightly inclined to facilitate drainage, and attention should be paid to laying the materials straight to prevent bending deformation.
7. The bottom of the stack of thick-walled steel pipes should be raised, firm and flat to prevent the material from being damp or deformed.
