Threeway Steel Co., Ltd
E-mail: sales@srtsteelpipe.com
Address: 22nd Floor, Royal Wing Tower, Long Champ International Building, No.9 Xiangfu Road, Changsha, Hunan, China, PC: 410116Phone:0086-731-8873-9521
Keywords :What is the difference between a long-radius steel elbow and a short-radius steel elbow Update : 2022-10-18 View(s) : 871
1. Different definitions Long radius steel elbow : Long radius steel elbow means that the radius of curvature of the steel elbow is 1.5 times the diameter of the pipe; if it is greater than 1.5 times, it is the category of steel elbow. Short radius steel elbow: Short radius steel elbow means ...
Keywords :The difference between a globe valve and a ball valve Update : 2022-10-17 View(s) : 706
The difference between the globe valve and ball valve is the more common two imported electric valves, both of which can be used for on/off or adjustment of water, steam, oil, gas, and other media, but there are still some differences between these two valves. This article describes in detail th...
Keywords :Spiral welded steel pipe and welded steel pipe which is better Update : 2022-10-14 View(s) : 816
1. The materials are the same and the uses are different, so there is no question of who is better. 2. Spiral welded steel pipe refers to a steel pipe with joints on the surface that are welded by bending and deforming a steel strip or steel plate into circular, square, or other shapes. Accord...
Keywords :Analysis of Pressure Grade of Carbon Steel Spiral Steel Pipe Update : 2022-10-13 View(s) : 1231
The pressure ratio of the spiral steel pipe on the gas pipeline also has a downward trend. For pipe diameter, pressure, and pressure ratio, it is necessary to carry out optimization calculations and comparisons. When the transmission volume is determined, after the pipe diameter, pressure, and p...
Keywords :What is the difference between welded steel pipe and welded spiral steel pipe Update : 2022-10-12 View(s) : 1004
Welded steel pipe refers to a steel pipe with seams on the surface that is welded by bending and deforming a steel strip or steel plate into a circular, square, or another shape. The blanks used for welded steel pipes are steel sheets or strips. Since the 1930s, with the rapid development of high-qu...