A range of steel sections can be used for piling pipe. The most common are tubes, universal columns (or H piling) and rectangular hollow sections. Driving piles, as opposed to drilling bores, can be advantageous because the soil displaced by driving the piles compresses the surrounding soil, resulting in greater friction against the sides of the piles, thus increasing their load-bearing capacity. In addition, as driving a pile displaces the soil rather than removes it, there is no cost of spoil disposal incurred. This can be particularly beneficial if the soil is contaminated.
A wide range of sizes of steel tube (or pipe) is commonly available and Piling Contractors have experience in driving tubes from 350 mm to 1500 mm diameter with wall thicknesses from 7 mm to 25 mm.
Piling pipe can be driven with either an open bottom end or closed end. When driven open end, soil is allowed to enter the bottom of the tube. If an empty pipe is required, an auger can be used to remove the soil inside following driving. If the soil is suitable internal cleaning could also be carried out by water jetting.
Closed end pipe piles have the bottom of the pile sealed with a steel plate or cast steel shoe. When driving through hard strata pile toes may be reinforced with a secondary driving shoe to assist penetration and minimise pile damage.
The structural capacity of tubular piles is primarily calculated based on steel strength and concrete strength (if filled). Corrosion can be dealt with by application of protective coatings, by allowing a sacrificial thickness of steel or by adopting a higher grade of steel than otherwise needed.
Piling pipe can either be new steel manufactured specifically for the piling industry or reclaimed steel tubular casing previously used for other purposes such as oil and gas exploration. Most steel tube piles can readily be spliced to provide greater depth capability than a driving rig can accommodate.
H-Piles and Universal Columns (UC’s) are structural beams that are driven in the ground for deep foundation application. They can be easily cut off or joined by cutting and welding. If a steel pile is driven into a low pH soils or where water flows readily then there is a risk of corrosion, coal-tar epoxy or cathodic protection can be applied to slow or eliminate the corrosion process.
Sometimes a combination of steel tubes and steel piles are used to make a “combi wall” this benefits from the strength properties of tubular piles but at reduced materials cost.
Threeway Steel is known as a professional supplier engaged in manufacturing and distributing a wide range of steel pipe, and our headquarter located the central part of China – Hunan and six associated factories throughout China.
Threeway Steel is known as a professional supplier engaged in designing, manufacturing and distribution of a wide range of steel products with the headquarter located the central part of China – Hunan and six associated factories throughout China.
Threeway Steel is known as a professional supplier engaged in designing, manufacturing and distribution of a wide range of steel products with the headquarter located the central part of China – Hunan and six associated factories throughout China.
Threeway Steel is known as a professional supplier engaged in designing, manufacturing and distribution of a wide range of steel products with the headquarter located the central part of China – Hunan and six associated factories throughout China.
Threeway Steel is known as a professional supplier engaged in designing, manufacturing and distribution of a wide range of steel products with the headquarter located the central part of China – Hunan and six associated factories throughout China.
